Pairing the sensors
Shared sensors
-
3 users
The sensors could be shared among 3 users - one Owner and 2 Guests. Each sensor stores these 3 users in its memory.
-
Owner
The first person to pair the sensor becomes the Owner. You get full control - including removing all users at once via the physical sensor reset button (8sec until white blink).
-
Guest
Guests can pair and use the sensor normally but can only release their own slot tapping Forget button for each sensor in tha app. They cannot remove other users or perform a full reset as Owner.
Step-by-step connection
Connect as Owner
-
1. Power On The Sensor
Be the first to press the button on the new or cleaned sensor until the blue LED flashes. The sensor is now discoverable.
-
2. Open The Connection Tab
Tap the Connect button for the first time to connect the sensors and the app. Later the app will attempt to pair automatically.
In the Left/Right cards you will see the status: Paired as Owner ・1/3 (one slot occupied out of 3).
-
3. Confirm Pairing
You are enrolled as Owner in Slot 0. Your device ID is saved to the sensor. Future connections are automatic.
⚠️ As Owner you can always perform a full reset by holding the sensor button for 8 seconds (white blink after red). This removes all users and clears all slots.
To clean ALL memory - tap Forget buttons for each sensor in the App and long press button on each sensor. Now the App and sensors are as new.
Connect as Guest
Get your sensors-
1. Power On The Sensor
The sensor must already have an Owner enrolled. Power it on; it does not need to be connected to the Owner's phone.
-
2. Open the Connection Tab
The sensor appears in the scan list. Tap Connect. The app checks for a free Guest slot. You will see: Paired as Guest
-
3. Done
Your device ID is saved to Slot 1 or Slot 2. You can now use the sensor independently.
⚠️ If both Guest slots are full, you cannot pair until an existing Guest releases their slot or the Owner performs a full reset.